عمود، ظرف حفر 3MT بقضيب سحب إلى خيط 3/8-24

The threading on the 3/8"-24 end matched perfectly with my chuck, and the 3 Morse taper seated securely with no wobble during operation. This arbor feels solidly machined and does exactly what it’s supposed to do for a straightforward setup.

Swapped out a worn arbor on my milling machine and the 3MT drawbar fit perfectly into the taper, no slop at all. The 3/8"-24 threads engaged cleanly with my chuck, and it's held tight through a few heavy cuts so far.

Was a little nervous about thread fit, but the 3/8"-24 side screwed on clean and the 3 Morse taper seated snug—no wobble at all. Exactly what I needed to swap chucks on my mill.