Bed Way, 20" Bench Lathe

The extra holes on my 9x20 needed drilling, but once that was done, the alignment was spot-on and my taper issues vanished completely. It's solidly built and way more precise than the stock bed it replaced.

I've been chasing a slight taper issue on my 8.5x20 and swapping in this bed way tightened everything right up. The machined surfaces are dead flat and the pre-drilled holes lined up perfectly with my existing carriage, so install took under an hour. Only nitpick is that you'll need a tap set if you

The cast iron on this bed way is machined really well, and the bolt holes lined up perfectly on my HiTorque 8.5x20. It slid right into place without any binding.