Lathe Dog, 10 mm

Snug fit on my 10 mm stock and it grips without marring the surface. Turning between centers finally feels solid instead of the work slipping. The tail is a bit long for my smallest faceplate but that's on my setup, not the dog.

The 10 mm capacity fits my stock perfectly and the dog bites down hard with no slipping. Turning between centers is finally painless on the mini lathe.

Grabbed this for turning between centers on my 7x14 and it clamps down on 10 mm stock with no slipping at all. The tail is short enough that it clears my tool post, which was the whole reason I needed a smaller dog.