Pin, M6x16, Tapered

The 6mm taper seated perfectly into the Z-axis bracket without any filing, which is exactly what I needed for that mill repair. It's a small part but the dimensions are precise, so the install took all of two minutes.

Had to swap out the old pin on my Z-axis bracket—this one matched the 6x16mm dimensions exactly. Tapers a bit more gradually than the original, but after a gentle tap it held the bracket securely. Minor complaint: the finish is slightly rougher than I'd like, yet it works fine for the price.

Finally got my SX2.7 Z-axis bracket sorted after losing the original pin—this M6x16 tapered one slid right into place. The taper holds it snug without any extra play. Only ding is it’s a bit pricey for a single piece of hardware.