What This Electrical Box Does
The rear electrical box on the HiTorque LED display mini lathe houses the main control panel and electrical supply connections. It is also used on SIEG SC20 mini lathes. Understanding its role helps you install or replace it correctly.
Before You Begin
Make sure the lathe is unplugged before working on any electrical components. The rear box connects to the front display box through a wiring conduit that passes through the headstock. You will need to access both the rear and front of the lathe.
Installation Steps
Follow these steps to mount the rear electrical box and route the wiring.
- Mount the Rear Box: Position the rear electrical box on the back of the lathe. Secure it using the original mounting screws or the hardware supplied with the replacement part.
- Route the Wiring Conduit: Feed the wiring from the rear box through the wiring conduit. The conduit passes through the headstock and ends at the front display box area. Ensure the wires are not pinched or kinked.
- Connect to the Front Display Box: Attach the wiring to the appropriate terminals inside the front display box. Refer to the lathe's wiring diagram for correct polarity and connections.
- Test the Connections: Before closing the boxes, gently tug each wire to verify a secure connection. Check that no bare wire is exposed beyond the terminal.
Compatibility and Catalog Details
- Electrical Box, Rear, HiTorque LED Display Mini Lathe: This rear electrical box is used on the HiTorque LED display mini lathe and SIEG SC20 mini lathes. If you own either model, this part is a direct fit. It houses the main control panel and electrical supply connections, making it essential for proper lathe operation.

Electrical Box, Rear, HiTorque LED Display Mini Lathe - Electrical Box, Rear, HiTorque LED Display Mini Lathe: Wiring from this box passes through a wiring conduit, through the headstock and into the front display box. The routing path is critical: the conduit protects the wires and must be correctly aligned to avoid damage when the headstock is moved or adjusted.
Checkpoints After Installation
After securing the box and connecting the wiring, verify that the control panel powers on and all functions respond correctly. Check that the wiring conduit does not interfere with the headstock movement. If you encounter any issues, double-check the wiring connections against the lathe's diagram.


