Tuyau de refroidissement, modulaire Ø 1/4", 12" long

I've been using this 12-inch modular hose on my lathe for a few weeks now, and the way you can snap extra segments on or off makes dialing in the coolant stream a breeze. The 1/4" ID fits perfectly with my existing setup without any leaks.

Finally got around to swapping out the old rigid tube and this modular hose makes routing the coolant on my mill so much easier. Each segment clicks together tightly with no leaks, and the 1/4" ID fits perfectly on my existing fittings.

The 12-inch length is just right for reaching over the mill table without extra slack getting in the way. I like that each section can be repositioned on the fly, so I can switch from spraying the cutter to flooding the vise in seconds. It's a solid little extension that does exactly what it should.