Spacer, Spindle Mini Lathe, 32 mm

The 40 mm OD is exactly what I needed to seat the rear bearing properly, and the 32 mm length gives a snug, secure fit on the spindle shaft. I’ve run a few test cuts since installing it and everything stays rock solid, no wobble at all.

The plastic spacer fit perfectly on the shaft, and the 32 mm length was exactly what I needed to eliminate wobble. It feels sturdy and straightforward to install.

Took a caliper to it before install and the 40 mm OD is dead-on, so no wobble once it’s seated behind the rear bearing. The 32 mm length gave just enough spacing without any filing, which is exactly what I needed.