칩 트레이, HiTorque 미니 밀

Swapping out the flimsy stock tray for this one was long overdue. It's thick enough that it doesn't flex when I lean on it, and the 0.9" depth actually catches the curls instead of letting them roll onto the bench.

The predrilled holes lined up perfectly with my mill base, so it bolted down in about five minutes without any drilling on my part. At 16 by 19 inches it catches nearly all the swarf and oil instead of letting it run onto the bench. Metal chips wipe right off the smooth surface.

Swapping the flimsy factory pan for this one made cleanup after milling aluminum so much easier, and the 0.9" lip actually holds the chips instead of letting them spill over the edge. The predrilled holes lined up with my mill, so it bolted down in a few minutes.