鳩尾銑刀，可轉位60度 3/4"直徑，2刃

The 3/4" diameter cuts clean dovetails in hardwood without chatter, and the two-flute design clears chips well. I used it with TDEX inserts for a furniture project and got a smooth finish on the first pass. The shank fits snugly in my router collet, which is nice.

The two-flute design really lets you push the feed rate without chatter, and the 3/4" diameter covers a lot of ground in one pass. I was a bit nervous about not having the inserts included, but pairing it with the TDEX 21.5s was straightforward. Cuts clean and true.

I swapped out my old solid carbide dovetail bit for this indexable one, and the change in cut quality on aluminum is impressive. The 60-degree angle cuts cleanly without chattering, even at higher feed rates.