銷規組，0.011" 至 0.060" 負公差

Finally, a pin gage set where the sizes are actually marked on each pin and the case keeps everything sorted. I've been using them to check drilled holes in aluminum parts, and the 0.011" to 0.060" range covers all my small work. The minus tolerance is a lifesaver for go/no-go checks.

The 2-inch length is perfect for reaching into deeper bores without wobbling, and the case keeps every single pin organized and protected. Checked a few tight tolerances on a prototype today and they slid in exactly as expected.

Third set I've bought from this same size range, and the 2" length makes reaching deep bores way easier than my old half-inch pins. The case keeps all fifty organized without any rattling around, which I appreciate when I'm switching sizes constantly at the bench.