感測器探頭，Z軸動力升降，HiTorque大型檯式銑床豪華版

The Z-axis sensor probe fit perfectly on my mill and the signal response is noticeably faster than the original. I appreciate that the connector was already pre-wired, which saved me a good 20 minutes of troubleshooting. It’s a simple swap that just works.

Swapped it in after the old one finally gave out, and the signal to the motor safety cut-off is much more responsive now. It's a direct fit for the Z-axis lift, so no fiddling with adapters or wiring. This little probe just saved me from a lot of headache down the road.

Took about ten minutes to swap out and the signal to the motor safety cut-off is instant, which gives me peace of mind when tramming the head. It’s a simple part, but it does exactly what it’s supposed to do.