Why the Left Lead Screw Support Matters
The lead screw on a 9x20 bench lathe spans the length of the bed, transferring motion from the drive to the carriage. Over time, the unsupported span can allow the screw to flex or vibrate, especially during heavy threading or power feed operations. The left side lead screw support bracket (the one on the drive side) stabilizes the screw at its input end, reducing deflection and helping maintain consistent thread pitch and surface finish.
This guide covers installation of the left lead screw support for HiTorque 9x20 bench lathes and SIEG SC4 bench lathes. The part is the support bracket on the left (drive) side of the lead screw—not the one on the tailstock end.
Installation Steps
- 1. Prepare the lathe: Disconnect power to the lathe. Remove the lead screw cover or chip tray if fitted. Clean any debris from the left end of the lead screw and the mounting area on the bed.
- 2. Position the support bracket: Slide the left lead screw support bracket over the lead screw from the drive end. The bracket should sit flush against the bed casting, with the screw passing through its bore. Do not force it; if alignment is off, check that the bracket is the correct side (left/drive side).
- 3. Align and secure: Align the bracket's mounting holes with the corresponding tapped holes on the bed. Insert the bolts (typically M6 or similar, check your lathe's hardware) and tighten them evenly. Apply moderate torque—overtightening can distort the bracket or bind the lead screw.
- 4. Check lead screw rotation: Rotate the lead screw by hand. It should turn smoothly with no binding. If it feels tight, loosen the bracket bolts slightly, rotate the screw a few turns, then retighten. This centers the bore naturally.
Product Facts: Left Lead Screw Support
- Support, Lead Screw Left, 9x20 Bench Lathe: Left side lead screw support for the HiTorque 9 x 20 bench lathes and SIEG SC4 bench lathes. This support is on the left (drive) side of the lead screw. Confirms the bracket is designed for your specific lathe model and that it goes on the drive end, not the tailstock end.

Support, Lead Screw Left, 9x20 Bench Lathe
Compatibility Notes
This support bracket fits HiTorque 9x20 bench lathes and SIEG SC4 bench lathes. It is specifically the left (drive) side bracket. If your lathe is a different brand or model (e.g., a 7x14 or 9x19), the mounting hole spacing or bore diameter may differ. Measure your lead screw diameter and bed hole pattern before ordering.
The bracket is sold as a single unit. No additional hardware is included in the standard variant, so have the correct bolts and washers ready. Check your lathe's manual for bolt size and torque specs if available.


