M4 Flat Washer Basics
- What is an M4 flat washer?
- An M4 flat washer is a small fastener component intended for use with M4-sized hardware. It has an outside diameter of 9 mm and a thickness of 0.8 to 1.0 mm, and it complies with ISO 7089 (DIN 125).
- Where do M4 flat washers typically get used on mini lathes and bench mills?
- M4 flat washers are commonly used under M4 screw heads or nuts to distribute load over a wider surface, protecting softer materials like aluminum or plastic from damage. They also help prevent loosening by providing a smoother bearing surface.
- What should I check before installing an M4 flat washer?
- Verify the washer's outside diameter and thickness match your application's clearance and stack-up requirements. The supplied specifications confirm a 9 mm outside diameter and 0.8 to 1.0 mm thickness, but you should also confirm that the hole size fits your M4 hardware without excessive play.
Installation Tips for M4 Flat Washers
When installing an M4 flat washer, place it between the fastener head or nut and the workpiece surface. Ensure the washer sits flat and is not deformed by over-tightening. For applications where vibration is common, consider using a lock washer in addition to the flat washer, but only if space allows.
Always inspect the washer for burrs or damage before reuse. A damaged washer can scratch the workpiece or reduce clamping force. If the washer shows signs of deformation or corrosion, replace it with a new one.
M4 Flat Washer Specifications
- Washer, M4 Flat: This M4 flat washer has an outside diameter of 9 mm and a thickness of 0.8 to 1.0 mm. These dimensions determine where the washer can fit and how much load it can distribute under an M4 screw or nut.

Washer, M4 Flat - Washer, M4 Flat: The washer complies with ISO 7089 (DIN 125). This standard ensures consistent dimensions and quality, so you can trust it to fit standard M4 hardware.
Common M4 Washer Questions
- Can I reuse an M4 flat washer?
- Reuse is possible if the washer is not deformed, cracked, or corroded. However, for critical assemblies, using a new washer is safer because a reused washer may not provide the same clamping consistency.
- What if the washer doesn't fit my application?
- If the 9 mm outside diameter or 0.8 to 1.0 mm thickness does not fit your clearance or load requirements, select a different size or type of washer. Do not force a washer into a space that is too tight.
- Are M4 flat washers suitable for all materials?
- They work well for most metals and plastics, but for very soft materials like thin aluminum or acrylic, a larger washer may be needed to spread the load further. The supplied information does not specify material compatibility, so test on a scrap piece if unsure.


