Back to Blog
How-to Guides 2026-11-11 Products for bench top machinists | LittleMachineShop.com 0 views

Using a Starrett Edge and Center Finder on a Mill

Using a Starrett Edge and Center Finder on a Mill

Learn how to use a Starrett double end edge and center finder to locate work edges and find centers on your bench mill. Practical steps for accurate mill setup.

What a Starrett Edge and Center Finder Does

A Starrett double end edge and center finder is a simple but essential tool for bench mill work. It helps you locate the exact edge of a workpiece or find the center of a round part, a stud, a dowel, or a scribed line. The tool has a 0.500” diameter body with two different contacts: one end has a 0.200” diameter contact for edge finding, and the other end has a pointed contact for centering. Both the body and contacts are made of tool steel, hardened, ground, and lapped to close tolerances for diameter and concentricity.

Using the Edge Finder End

To locate a work edge, install the edge finder in a collet or drill chuck with the 0.200” diameter contact end pointing down. Lightly touch the contact against the workpiece edge while the spindle is running at a moderate speed. As the contact touches the edge, it will wobble and then snap into alignment. At that point, the edge of the contact is exactly at the workpiece edge. You can then move the mill table half the contact diameter to align the spindle center with the edge. The same technique works for flat edges, shoulders, and grooves.

Product Facts

  • Edge and Center Finder, 1/2" Shank, Starrett: Starrett double end edge and center finder. Starrett catalog number 827B. Body is 0.500” diameter. One end has a 0.200” diameter contact. The other end has a pointed contact. The two ends let you switch between edge finding and center finding without changing tools. The 0.500” body fits standard 1/2” collets and chucks common on bench mills.
    Edge and Center Finder, 1/2" Shank, Starrett
    Edge and Center Finder, 1/2" Shank, Starrett

Using the Center Finder End

For centering on round work, studs, dowels, or center points, use the pointed contact end. Mount the tool with the pointed end down. Bring the point close to the center of the workpiece. With the spindle running, move the table until the point aligns with the center mark or the center of the round part. The point will stop wobbling when it is centered. This method also works for locating scribed lines.

Tips for Accurate Use

Keep the tool clean and free of chips. The close-tolerance construction means even a small burr can affect accuracy. Use a light touch when contacting the workpiece to avoid deflecting the contact. For repeatability, approach the edge at the same speed each time. The edge finder is not intended for heavy contact—it is a locating tool, not a cutting tool.

Related Articles

Customer Service
Home
Products
Cart
Profile